Our Roofing Services | Angwin, CA
Angwin Roofing & Maintenance provides residential and commercial roofing services throughout Angwin and Anaheim, Burney, Corte Madera, Fawnskin, Hermosa Beach. Free estimates on every service listed here.
Roof Replacement
Full roof replacement starts with a complete tear-off down to the deck. We inspect every board for rot or soft spots. In Angwin, we find decking damage on about 30% of tear-offs. Damaged sections get replaced with CDX plywood before anything else goes on. Then we build up: ice and water shield in valleys and at eaves, synthetic underlayment across the full deck, new drip edge on every edge, starter strip, field shingles, hip and ridge caps, and ridge vent. Dumpster, permits, and cleanup included.
Get a Free Quote →
Roof Repair
We warranty every repair for 5 years. If the same area leaks again due to our workmanship, we come back free. That warranty is in writing and it means something because we're a local Angwin company. We're not disappearing.
Get a Free Quote →
Storm Damage Repair
Wind speeds above 60 mph cause shingle tab lift and adhesive seal failure per ASTM D7158 testing protocols. Our Angwin inspectors check the entire windward exposure. Not just the obvious damage. Poor ventilation causes ice dams which cause water intrusion under the shingle field during freeze-thaw cycles. We document all contributing factors so your insurance claim covers root-cause repairs, not just surface patches.
Get a Free Quote →
New Roof Installation
New construction underlayment per IRC R905 and ASTM D226 (felt) or ASTM D6757 (synthetic). Ice barrier per ASTM D1970 required at eaves in climate zones with average January temperature below 25°F. We install ice and water shield regardless. It's cheap insurance against ice dams and wind-driven rain. Drip edge per IRC R905.2.8.5 on eave and rake edges. Proper starter strip with factory sealant for wind resistance from day one.
Get a Free Quote →
Metal Roofing
Metal roof repairs are usually sealant failures at transitions, loose panels from improper installation, or rust spots on older galvanized systems. Our Angwin crew repairs all metal types. Not every issue needs a full replacement. Sometimes a sealant touch-up or panel re-securing solves it.
Get a Free Quote →
Shingle Roofing
The difference between a cheap shingle roof and a quality one comes down to the system underneath. Shingles are only the outer layer. Ice and water shield in the valleys, synthetic underlayment across the deck, proper starter strip with factory adhesive, correct nailing pattern. That's what makes a shingle roof last in California's weather.
Get a Free Quote →
Flat Roofing
Flat roof leak detection in Angwin: we start with a visual inspection of seams, flashings, and penetrations. If the leak source isn't obvious, we use electronic leak detection (ELD) or flood testing on membrane roofs. We find it and fix it. No guessing, no unnecessary tear-offs.
Get a Free Quote →
Commercial Roofing
We install Carlisle SynTec and Firestone TPO membrane systems in 60-mil and 80-mil thickness over minimum R-25 polyiso insulation (more in climate zones requiring it). Seams hot-air welded at 900°F+ and tested with a seam probe. Fully adhered systems for wind uplift zones per FM I-90 or I-120. Mechanically attached for re-roofs over existing insulation. NRCA member, trained per manufacturer specifications.
Get a Free Quote →
Gutter Installation
We custom-form seamless aluminum gutters on-site from a continuous coil of .027 gauge stock. No factory seams means no seam failures. We form them to the exact length your fascia requires. One piece, one gutter, no leaks.
Get a Free Quote →
Roof Inspection
We don't inspect roofs from the ground with binoculars. We get on the roof. Every inspection includes a full walkthrough: shingle condition, flashing integrity, pipe boots, ridge vent, soffit ventilation, gutter function, and visible attic moisture signs. You get photos and a written report.
Get a Free Quote →
Emergency Roof Repair
After we secure the tarp and stop the leak, we photograph and document everything while the damage is fresh. This documentation is critical for insurance claims. Adjusters want to see the damage before any repairs are made.
Get a Free Quote →
Skylight Installation
Skylight installation includes cutting the roof opening, framing a curb with doubled 2x lumber, installing the unit with factory sealant, and weaving the step flashing into the surrounding shingle courses. Interior work includes drywall framing and trim. We handle the full job in Angwin. Outside and inside.
Get a Free Quote →